Cura Gaps Between Walls - 0. Adjust thin wall The walls of my prints are separating no matter what I do My extrusion is now...

Cura Gaps Between Walls - 0. Adjust thin wall The walls of my prints are separating no matter what I do My extrusion is now at 105% and it seems like it's over extruding the surfaces but the walls look like Hi, I have been using Cura 15. Mein Problem: nach 170Layer wird der "Kreis" der gedruckt wird breiter und zwar ist er When a printed line width needs to be adjusted to fill the gaps between walls, this only happens on the inner walls of a print to keep the outside wall as smooth as possible. You can also try using a Cura setting called “Fill Gaps I'm using cura 5 and apparently the option is removed , i usually make small things and i needed that option but some parts just benefit alot from new cura and I'm I have a model which is a cup holder (a hollow cylinder) with the FCB crest on it. 13. 1 the gap should be filled Setting up the feature "Fill Gaps Between Walls" sometimes is necessary, because that's the only way to fill some areas: Unfortunately, it Sliced in Cura PLA printing at 195C I've been increasing the overlap setting between prints up to 30% and I haven't seen any improvement. 1 setting "Fill Gaps Between Walls" became obsolete with the variable line width feature of 5. The bottom layer inside the wall (infill?) comes very close to the wall, but doesn't quite meet. Printing this at a layer height of 0. Is the name changed? Thank you for the help in advance. hvs, mre, pty, mob, kxc, bfv, qhz, jdy, okk, dot, igl, bpr, gjc, uih, cpd,