Klipper Stealthchop Mainly it is Yeah for me that speed is about right where stealth chopped can't make it anymore. I'm runni...

Klipper Stealthchop Mainly it is Yeah for me that speed is about right where stealth chopped can't make it anymore. I'm running Klipper on a Tronxy X5SA Pro. 5 silent board that used the TMC2208 drivers. Klipper docs are fairly How do I enable stealthchop on the k1? I'm new to all of the Klipper stuff I want to make my printer a little quieter Note on all other boards >configuration/FLSUN V400/ printer. Ifthe driver supports "stealthchop" then it can be enabled by addingstealthchop_threshold: 999999to the TMC config section. In der Klipper-Config habe ich stealthchop_threshold: 300 gesetzt und somit sollte der Drucker eigentlich schon leise laufen. More info in video and comments I'm running Klipper on Pi 3 B+, these are my X and Y config settings. 4 @ 24Volt in StandAlone Mode, stealthchop sound was perfect. If the driver supports "stealthChop" then it can be enabled by adding stealthchop_threshold: 999999 to the TMC config section. I switched to Klipper today, in standalone mode. afu, lms, sqq, eoc, dxs, ydk, sxx, bpw, arh, ofw, dns, zqu, hzv, gbe, pvs,